Cpu And Chassis Fan Connectors (4-Pin Cpu_Fan, 4-Pin Cha_Fan) - Asus E3M-PLUS V5 User Manual

3.

CPU and chassis fan connectors (4-pin CPU_FAN, 4-pin CHA_FAN)

Connect the fan cables to the fan connectors on the motherboard, ensuring that the
black wire of each cable matches the ground pin of the connector.
E3M-PLUS V5
E3M-PLUS V5 Fan connectors
Do not forget to connect the fan cables to the fan connectors. Insufficient air flow inside
the system may damage the motherboard components. These are not jumpers! Do not
place jumper caps on the fan connectors! The CPU_FAN connector supports a CPU fan of
maximum 1A (12 W) fan power.
4. USB 2.0 connectors (10-1 pin USB910, USB1112)
These connectors are for USB 2.0 ports. Connect the USB module cable to any of
these connectors, then install the module to a slot opening at the back of the system
chassis. These USB connectors comply with USB 2.0 specifications and supports up to
480Mbps connection speed.
E3M-PLUS V5
E3M-PLUS V5 USB2.0 connectors
Never connect a 1394 cable to the USB connectors. Doing so will damage the
motherboard!
The USB 2.0 module is purchased separately.
1-14
CPU_FAN
CHA_FAN
GND
CHA FAN PWR
CHA FAN IN
+5V
USB910 USB1112
PIN 1 PIN 1
Chapter 1: Product introduction