AEG S74010KDX1 User Manual page 17

3
5. Remove the door.
6. Position the pin and the washers on
the opposite side (4).
7. Unscrew the upper pin (1) and screw
it on the opposite side. (2)
2
8. Remove the handle. Unscrew the top
handle bracket from the handle rod
(1). Unscrew the bottom handle
bracket from the door (2)
9. Unscrew the top handle bracket from
the door (3).
1
2
10. Re-screw the handle bracket on the
door (4). Turn the handle bracket with
4
2
5
1
1
3
the handle and screw them to the
door (5) and the fitted handle bracket
(6)
5
4
11. Re-insert the door on the lower hinge
pivot .
12. Re-insert the door on the upper
hinge pivot slightly tilting the door.
13. Screw the lower hinges.
14. Refit the plinth.
CAUTION!
Reposition, level the
appliance, wait for at least
four hours and then connect
it to the power socket.
Do a final check to make
sure that:
• All screws are tightened.
• The magnetic seal
adheres to the cabinet.
• The door opens and
closes correctly.
If the ambient temperature
is cold (i.e. in Winter), the
gasket may not fit perfectly
to the cabinet. In that case,
wait for the natural fitting of
the gasket.
In case you do not want to
carry out the above
mentioned operations,
contact the nearest After
Sales Service Force. The
After Sales Service specialist
will carry out the reversibility
of the doors at your cost.
CAUTION!
Reposition, level the
appliance, wait for at least
four hours and then connect
it to the power socket.
ENGLISH 17
6