Rear Spacers; Door Reversibility; Removing The Shelf Holders - AEG S74010KDX1 User Manual

16 www.aeg.com

9.4 Rear spacers

You can find the two spacers in the bag
with documentation.
1. Release the screw.
2. Engage the spacer below the screw.
3. Turn the spacer to the right position.
4. Tighten again the screws.
9.5 Levelling
Accurate levelling prevents the vibration
and noise of the appliance during
operation.
To adjust the heigh of the appliance
loosen or tighten the two adjustable
front feet.

9.6 Removing the shelf holders

Your appliance is equipped with shelf
retainers that make it possible to secure
the shelves during transportation.
1. Move the shelf holders in the
direction of the arrow (A).
2. Raise the shelf from the rear and
push it forward until it is freed (B).
3. Remove the retainers (C).
2
1
3
4
1

9.7 Door reversibility

WARNING!
Before carrying out any
operations, remove the plug
from the power socket.
CAUTION!
To carry out the following
operations, we suggest that
this be made with another
person that will keep a firm
hold on the doors of the
appliance during the
operations.
Before carrying out any
operation, please be sure
that the appliance is empty.
If not, please move all goods
into right temperature for
proper food storage reason.
1. Tilt back the appliance carefully so
that the compressor cannot touch
the floor.
2. Remove the plinth. (1)
3. Remove the cap (2) and position it on
the opposite side.
4. Unscrew the lower pin and remove
the washers (3)
2
3