Hydraulic System Maintenance; Check Auxiliary Hydraulic Oil Level; Check Hydraulic Transmission Oil Level; Change Auxiliary Hydraulic Reservoir Fluid And Filter - Toro 23518 Operator's Manual

30in stand-on aerator
Hide thumbs Also See for 23518:
Table of Contents

Advertisement

7. Repeat steps 3 through 6 for other motion control
linkage.
Hydraulic System
Maintenance
Check Auxiliary Hydraulic Oil
Level
Service Interval: Every 50 hours
1. Lower the tines to the ground.
2. Stop engine and wait for all moving parts to stop, and
remove key. Engage parking brake.
3. Clean area around hydraulic reservoir cap and remove
cap. Oil level should be to the top of the baffle inside
the tank. If not, add oil. Use AW-32 hydro oil. Replace
hydraulic reservoir cap and tighten until snug. Do not
overtighten.
Note: The baffle is labeled Hot and Cold. The oil
level varies with the temperature of the oil. The Hot
level shows the level of oil when it is at 107°C (225°F).
The Cold level shows the level of the oil when it is at
24°C (75°F). Fill to the appropriate level depending
upon the temperature of the oil. For example: If the
oil is about 65°C (150°F), fill to halfway between the
Hot and Cold levels. If the oil is at room temperature
(about 24°C (75°F)), fill only to the Cold level.
Check Hydraulic Transmission
Oil Level
Service Interval: Every 50 hours
1. Stop engine and wait for all moving parts to stop, and
remove key. Engage parking brake.
2. With the unit cold, check the expansion tank and if
necessary add Toro Hypr-oil 500 hydraulic oil to the
Full Cold line.
Change Auxiliary Hydraulic
Reservoir Fluid and Filter
Service Interval: After the first 100 hours
Every 250 hours thereafter
1. Stop engine, wait for all moving parts to stop, and
remove key or spark plug wire(s). Engage parking
brake.
2. Carefully clean area around the front of the auxiliary
pump and fill cap; also clean around the filter. It is
important that no dirt or contamination enter hydraulic
system.
3. Unscrew the suction hose from the pump fitting, clean
around the pump fitting, and allow oil to drain.
4. Unscrew the filter to remove and allow oil to drain.
32

Advertisement

Table of Contents
loading

This manual is also suitable for:

33518

Table of Contents