Side-Discharging The Clippings; Installing The Grass Bag - Toro Recycler 20960 Operator's Manual

Installing the Grass Bag

1. Raise and hold up the rear deflector
Figure 22
1. Rear deflector
2. Notches (2)
2. Install the grass bag, ensuring that the pins on the bag
rest in the notches on the handle
3. Lower the rear deflector.
Removing the Grass Bag
To remove the bag, reverse the steps above.
Operating the Bag-on-Demand Lever
The bag-on-demand feature allows you to either collect or
recycle grass and leaf clippings while the grass bag is attached
to the machine.
•
For bagging the grass and leaf clippings, press the button
on the bag-on-demand lever, and move the lever forward
until the button on the lever pops up
Figure 23
1. Bag-on-demand lever (in bagging position)
•
For recycling the grass and leaf clippings, press the button
on the lever and move the lever rearward until the button
on the lever pops up.
(Figure 22).
3. Grass bag pin (2)
(Figure 22).
(Figure 23).
Important: For proper operation, remove any grass
clippings and debris from the bag-on-demand door
and the surrounding opening
move the bag-on-demand lever from one position
to another.
1. Clean here
Side-Discharging the
Clippings
Use the side discharge for cutting very tall grass.
If the grass bag is on the machine and the bag-on-demand
lever is in the bagging position, move the lever to the recycling
position; refer to Operating the Bag-on-Demand Lever (page
12).
Installing the Side-Discharge Chute
Lift up the side deflector and install the side-discharge chute
(Figure 25).
12
(Figure 24) before you
Figure 24