Connecting The Subwoofer; Connecting The Speaker Cables; Connecting The Speakers - Onkyo SKS-HT235 Instruction Manual

5.1 ch home theater speaker package

Hide thumbs

Table Of Contents

Table of Contents

SKS-HT235.book Page 8 Friday, June 18, 2004 9:05 AM

Connecting the Speakers

Read the following before connecting your speakers:

• Turn off your amp before making any connections.

• The nominal impedance of these speakers is 8 Ω . Use

only an amp that supports this impedance.

• Pay close attention to speaker wiring polarity. Connect

positive (+) terminals to only positive (+) terminals,

and negative (–) terminals to only negative (–) termi-

nals. If the speakers are wired incorrectly, the sound

will be out of phase and will sound unnatural.

• Be careful not to short the posi-

tive and negative wires. Doing so

may damage your amp.

Connecting the Speaker Cables

Use the cables to connect each speaker's

input terminals to the corresponding

speaker output terminals on your amp.

To make a connection, while

pressing the terminal lever,

insert the wire into the hole, and

then release the lever.

Make sure that the terminals are

gripping the bare wires, not the insulation.

En-