Table of Contents
Advertisement
q
e
z
q
w
e
x
c
w
r
r
t
y
Square Buttonhole
Machine settings
q Pattern:
w Thread tension:
e Presser foot:
r Foot pressure:
The size of a buttonhole is automatically set by placing a
button in the rear of automatic buttonhole foot R.
The button holder of the foot takes a button size of 1 cm
(3/8˝) to 2.5 cm (1˝) in diameter.
When selecting the buttonholes, the LCD screen advise
you to lower the buttonhole lever.
NOTE:
It is sometimes necessary to change buttonhole size
to match certain heavy or specific fabrics and threads.
Make a test buttonhole on an extra piece of the fabric
to check your settings.
The preset width of the buttonhole is suited for
ordinary buttons.
Apply an interfacing to stretch or fine fabrics.
Sewing
z Pull the button holder to the back, and place the
button in it. Push it together tightly on the button.
q Button holder
NOTE:
Check the length of the test buttonhole, and adjust the
buttonhole length if necessary by turning the adjusting
screw on the buttonhole foot.
To increase the buttonhole length, turn the adjusting
screw to move the marker toward "L".
To decrease the buttonhole length, turn the adjusting
screw to move the marker toward "S".
w Adjusting screw
e Marker
x Press the needle up/down button to raise the needle.
Press the lockout key.
Attach the automatic buttonhole foot R snapping the
pin into the groove of the foot holder.
You may lift the presser foot lifter to the extra lifted
position when placing the automatic buttonhole foot
under the foot holder.
Raise the presser foot.
r Groove
t Pin
c Draw the needle thread to the left through the hole of
foot.
Mark the buttonhole position on the fabric and place
it under the buttonhole foot. Lower the needle at the
starting point by turning the handwheel.
y Starting point
47
MODE 1: 23
AUTO
Automatic buttonhole foot R
5
Advertisement
Table of Contents
