Samsung RS26DDA series User Manual page 20

setting up your side-by-side refrigerator
Removing r
1. Turn ON the main water supply.
2. Press the Water button and push the dispenser pad.
Refer to 'Checking the control panel' in the manual (page 20)
3. Flush 3 gallons of water thr
(Flush approximately 6 minutes.)
This will clean the water supply system and remove air from the lines.
4.
5. Open the refrigerator door and make sure there are no water leaks coming
fr
getting into the line. It should pose no problem to operation.
Check the amount of water supplied to the ice tray
1. Lift up and pull out the Ice maker bucket in the freezer.
2. When you press the Test button for 3 seconds,
the water supply tap. Put a bowl before you
press the test button and check to make
sure the amount of water is correct (see the
illustration). If the water level is too low, the ice
cubes will be small. This is not a problem with
the ice maker but of the water pressure in the
pipe.
3. In case ice does not come out, pull out the ice bucket and
press test button located on the bottom of ice maker.
20_setting up
equired in some households.
.
om the water dispenser. This is due to air
om
Ice
Water