Setting Up The Refrigerator - Samsung RS26DDA series User Manual

doorways (both width and height), thresholds, ceilings, stairways, etc.
The following chart details the exact height and depth.
Dimensions
[inch(mm)]
• Allow clearance to the right, left, back and top when installing. This will help reduce power
consumption and keep your energy bills lower.
• Make sure you disconnect the water supply line BEFORE removing the freezer door.
To avoid damage, refer to 'Separating the water line from the refrigerator' in the manual
(page 12).

SETTING UP THE REFRIGERATOR

Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and
functions of the appliance. By completing the following steps, your Refrigerator should be fully operational.
this user' s guide. If you have any further questions, contact your Samsung Electronics service center.
1. Place the Refrigerator in an appropriate location with reasonable clearance between the wall and the
Refrigerator. Refer to installation instructions in this manual.
2. Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3. Set the Temperature control [Refer to 'Freezer/Fridge(Temperature adjustment)', page 21] to the coldest
temperature and wait for an hour. The Freezer will get slightly chilled and the motor will run smoothly.
4. After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can
5. Assemble the water line to the refrigerator and verify that the couplers are correctly assembled without
water leakage. (Refer to 'Installing the water line, page 17~18)
Check the accessory list below.
MODEL
Only Cabinet
Width
With Leg Front
Only Cabinet
Depth With Door
With Handle
Only Cabinet
Height With Hinge
With Door
35" 3/4 (908 mm)
36" (914.4 mm)
30" 1/16 (763.3 mm)
34" 29/64 (875mm)
37" (940 mm)
68" 1/2 (1,740 mm)
69" 9/32 (1,760 mm)
69" 7/8 (1,775 mm)
setting up _11