Onkyo SKC-230C Instruction Manual page 7

SKS-HT230_En.fm Page 7 Friday, January 16, 2004 4:54 PM
Various Mounting Methods —Continued
■ Mounting horizontally
To mount the center speaker horizontally, use the two
keyhole slots shown to hang each speaker on two screws
that are securely screwed into the wall.
Center speaker
Keyhole slots for horizontal
wall mounting
Spacers
75 mm 190 mm
Caution:
A mounting screw's ability to support a speaker depends
on how well it's anchored to the wall. If you have hollow
walls, screw each mounting screw into a stud. If there are
no studs, or the walls are solid, use suitable wall anchors.
Use screws with a head diameter of 9.5 mm or less and a
shank diameter of 4 mm or less. With hollow walls, use
a cable/pipe detector to check for any power cables or
water pipes before making any holes.
Leave a gap of between 7 mm and 10 mm between the
wall and the base of the screw head, as shown.
7 mm–10 mm
(We recommend that you consult a home installation
professional.)
Spacers
65 mm
65 mm
75 mm
Wall
Using Speaker Mounts/Brackets
Threaded inserts for M5 screws are provided on the rear
of each speaker for wall-mounting with commercially
available speaker mounts and brackets. Refer to the man-
ual supplied with your mounts or brackets for installa-
tion details.
Use this hole if mounting
vertically
Use this hole if mounting
horizontally
Note:
The portion of the screw that goes into the speaker's
threaded insert should be between 5 mm and 9 mm long,
as shown.
Mount or bracket
5 mm–9 mm
Using the supplied cork spacers
■ Using cork spacers with the subwoofer
(SKW-150X)
We recommend using the supplied cork spacers to
achieve the best possible sound from your speaker. The
cork spacers prevent the speaker from moving, providing
a more stable setup.
5 mm
Cork spacers
Bottom of the
SKW-150X
7