Toro 30635 Operator's Manual page 30

spacers onto the spindle shaft. Install the tensioning
cap to secure the assembly.
4. Remove the hairpin cotter and clevis pins from the
castor pivot arms (Figure
5. Rotate tension rod to raise or lower pivot arm until
holes are aligned with selected height-of-cut bracket
holes in the cutting unit frame
24).
6. Insert the clevis pins and install the hairpin cotters.
7. Rotate tension rod counterclockwise (finger tight) to
put tension on adjustment.
Figure 23
1. Castor pivot arm
2. Axle mounting holes
Figure 24
8. Remove the hairpin cotters and clevis pins securing
the damper links to the cutting unit brackets
25). Align the damper link holes with the selected
height-of-cut bracket holes in the cutting unit frame
(Figure 26), insert the clevis pins, and install the hairpin
cotters.
Important: The damper link length should never
be adjusted. The length between the hole centers
should be 13.7 cm (5-3/8 inches).
23).
(Figure 23 and Figure
3. Clevis pin and hair pin
cotter
4. Tension rod
(Figure
1. Damper link
Adjusting the Skids
The skids should be mounted in the lower position when
operating at heights of cut greater than 64 mm (2-1/2 inches)
and in the higher position when operating at heights of cut
lower than 64 mm (2-1/2 inches).
Note: When the skids become worn, you can switch the skid
to the opposite sides of the mower, flipping them over. This
will allow you to use the skids longer before replacing them.
1. Loosen the screw at the front of each skid
30
Figure 25
Figure 26
(Figure
Figure 27
27).