Table of Contents
Advertisement
Maintenance
NOTICE:Maintenance, replacement or repair of the
emission control devices and systems may be
performed by any non-road engine repair
establishment or individual. However, to obtain no
charge repairs under the terms and provisions of the
Toro warranty statement, any service or emission
control part repair or replacement must be performed
by an Authorized Toro Service Dealer.
Figure 14
1. Housing (straight shaft)
2. Housing (curved shaft)
3. Eyelet (2)
4. Spool (with Line)
Air Filter
Maintenance Interval
The air filter should be cleaned daily, or more often
when working in extremely dusty conditions.
Replace after every 100 hours of operation.
Air Filter Cleaning
1. Loosen the knob and remove the air filter cover
(Fig. 15).
2. Remove the foam ring and filter screen from the air
filter cover (Fig. 15).
3. Clean the foam ring and filter screen with warm, soapy
water. Let the screen and ring dry completely.
4. Apply a light coat of SAE 30 motor oil to the foam
ring and squeeze out all excess oil.
IMPORTANT: The air filter screen is designed to fit
into the air filter cover ONE WAY ONLY. Make sure
the cutouts in the screen fit onto the matching plastic
posts in the air filter cover. The fit should be snug (Fig.
15).
5. Spring
6. Bump Knob
7. Spool Cover
14
Figure 15
1. Air Filter Cover
2. Filter Screen
5. Reassemble the filter screen and foam ring to the air
filter cover (Fig. 16).
Figure 16
1. Filter Screen
2. Cutout (typical)
3. Foam Ring
3. Air Filter Cover
4. Plastic Post (typical)
Advertisement
Table of Contents
