Asus N3050T User Manual page 11

Flat panel display brightness connector (8-pin LCD_BLKT_PANEL)
This connector is for the LCD panel backlight and brightness controls. It enables
the LCD panel backlight, provides backlight control signals, and provides brightness
control signals for the brightness button on the front panel.
Intel Celeron
®
The motherboard comes with an onboard Intel
RTC Battery header (2-pin BATT_CON)
This connector is for the lithium CMOS battery.
Display panel VCC power selector (VCC_PWR_SEL)
VCC_PWR_SEL
1
3V 5V
(Default)
DDR3 DIMM slots
Install 2 GB, 4 GB, and 8 GB unbuffered non-ECC DDR3 DIMMs into these DIMM
sockets.
TPM connector (14-1 pin TPM)
This connector supports a Trusted Platform Module (TPM) system, which can
securely store keys, digital certificates, passwords and data. A TPM system also
helps enhance network security, protects digital identities, and ensures platform
integrity.
DMIC connector (4-pin DMIC)
The DMIC connector is for connecting the digital microphone module used in All-in-
One chassis.
Chassis intrusion header (4-1 pin CHASSIS)
This header is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this header. The chassis
intrusion sensor or switch sends a high-level signal to this header when a chassis
component is removed or replaced. The signal is then generated as a chassis
intrusion event.
By default, the pin labeled "Chassis Signal" and "Ground" are shorted with a jumper
cap. Remove the jumper caps only when you intend to use the chassis intrusion
detection feature.
Front panel audio connector (10-1 pin AAFP)
This connector is for a chassis-mounted front panel audio I/O module that supports
either HD Audio or legacy AC`97 audio standard. Connect one end of the front
panel audio I/O module cable to this connector
ASUS N3050T
Dual-core N3050 Processor
®
Pins
1 (Default)
2
3 2
12V
3
Celeron Dual-core processor.
® ®
Setting
3V
5V
12V
1-3