Table of Contents
Advertisement
Figure 16
1. Tilt steering control
Never raise the deck while the blades are
rotating. Contact with rotating blades can
cause serious injury.
Hydraulic Lift Lever
The hydraulic lift lever (Figure 17) has three lever
positions that actuate four operating modes; LIFT,
LOWER, FLOAT & HOLD. To lower the deck,
in preparation for mowing, lightly tap the lever
forward and then allow the lever to freely return.
This will allow the deck to drop at a controlled
rate and enables the deck ground following float
function. If the lever is held in the forward
(LOWER) position, the deck will drop quickly.
To raise the deck and hold it in the transport
position, pull and hold the lift lever rearward until
the deck has fully raised, then release the lever to
allow it to return. The deck will now hold in the
transport position. The deck must be raised when
transporting between mowing locations. The deck
should be lowered when not in use.
Figure 17
1. Hydraulic Lift lever
2. PTO Switch
3. Ignition switch
4. Throttle
5. Hour meter
6. Engine coolant
temperature indicator
PTO Switch
Pull up on the switch knob to engage the electric
PTO clutch (Figure 17). Push down on the knob
to disengage the electric PTO clutch. The only
time the PTO switch should be in the engage
position is when the implement is down in the
operating position and ready to begin operation.
If the operator leaves the seat when the PTO
switch is engaged, the machine will shut down. To
re-engage the PTO, push down and pull up on the
knob.
Fuel Gauge
The fuel gauge (Figure 18) indicates quantity of
fuel remaining in fuel tank.
27
7. Oil pressure indicator
8. Glow plug indicator
9. Charge indicator
10. Lift lever lock
11. Power point
Advertisement
Table of Contents
