Using the Remote Controller
Installing the Batteries
Note
• If the remote controller
doesn't work reliably, try
replacing the batteries.
• Don't mix new and old
batteries or different
types of batteries.
• If you intend not to use
the remote controller for
a long time, remove the batteries to prevent damage from leak-
age or corrosion.
• Remove expired batteries as soon as possible to prevent damage
from leakage or corrosion.
Aiming the Remote Controller
To use the remote controller, point it at the AV receiver's
remote control sensor, as shown below.
Remote control sensor
Batteries (AA/R6)
AV receiver
Approx. 16 ft. (5 m)
Contents
Introduction
Precautions ....................................................................... 3
Features ............................................................................ 6
Speaker Package .............................................................. 9
Turning On & Basic Operations
Basic Operations ............................................................ 22
Recording........................................................................ 27
Advanced Operations
Advanced Setup ............................................................. 33
Zone 2.............................................................................. 44
Controlling iPod & Other Components
Controlling iPod ............................................................. 47
Others
Troubleshooting ............................................................. 54
Specifications ................................................................. 58
About HDMI ..................................................................... 60
To reset the AV receiver to its factory defaults, turn it
on and, while holding down VCR/DVR, press
ON/STANDBY
(➔
54).
En
5