Onkyo DV-L55 Instruction Manual page 51

DV-L55_En.book Page 51 Friday, May 28, 2004 12:02 PM
Troubleshooting —Continued
Buttons on the DV-L55
and remote controller
don't work?
No sound?
The picture appears
stretched or the wrong
shape?
Audio CD playback
skips or jumps or is
noisy?
An audio CD is loaded
but the DV-L55 displays
"NO DISC"?
The first track doesn't
play?
Locating a specific
point takes longer than
usual?
Playback starts in the
middle of a track?
Some sections of a
track are skipped?
Playback stops in the
middle of a track?
The DV-L55 displays the
wrong messages?
Some MP3 files don't
play?
Power supply voltage fluctuations and
other anomalies, such as static electricity,
can interfere with normal operation.
The 96 kHz PCM Out setting is set to
"96 kHz."
The Digital Out setting is set to "Off."
The wrong input source is selected on
your TV, hi-fi amp, or AV receiver.
The audio cable is not connected properly.
The TV, hi-fi amp, or AV receiver con-
nected to the DV-L55's audio outputs is
either not on or its volume is turned down.
A DV-L55 Digital Audio Out setting is set
incorrectly.
Playback is paused.
The DVD-Video disc or CD uses the DTS
audio format and you are using the analog
outputs.
The TV Screen setting is wrong.
The Zoom function is being used.
The loaded audio CD uses copy control.
MP3 files without a ".mp3" or ".MP3"
filename extension are not recognized.
The MP3 disc contains over 299 folders
and 648 folders and files combined.
The MP3 disc is a multisession disc.
Turn off the DV-L55, wait five seconds, then turn
it on again. If that doesn't resolve the issue, dis-
connect the power cord from the wall outlet, wait
five seconds, reconnect it, then try again.
Change the 96 kHz PCM Out setting to "96 kHz >
48 kHz," or use analog connections (page 41).
Change the Digital Out setting to "On" (page 41).
On your TV, hi-fi amp, or AV receiver, select the
input to which the DV-L55 is connected.
Check the audio cable and correct as necessary
(page 20).
Turn on the TV, hi-fi amp, or AV receiver and set
its volume as appropriate.
Check the Digital Audio Out settings and correct
as necessary (page 41).
Resume playback (page 26).
DTS audio is only output by the digital outputs. To
play DTS material you need to connect one of the
DV-L55's digital outputs to a digital input on a
hi-fi amp or AV receiver that has a DTS decoder
built-in (page 20).
Set the TV Screen setting to match the aspect ratio
of your TV (page 41).
Select the Normal setting by pressing the ZOOM
button.
Copy-controlled CDs are special discs that don't
conform to the audio CD standard and, therefore,
may not work properly with the DV-L55.
Use the correct filename extension (page 8).
The DV-L55 recognizes only the first 299 folders
and 648 folders and files combined. Folders in
excess of this aren't recognized and cannot be
played (page 8).
The DV-L55 doesn't fully support multisession
discs. Only files in the first session can be played
(page 8).
51