the handle latches to the handle into the other
mounting holes in the latches.
3. Slide the bag support rod through the second from
the top mounting holes in the handle and secure
each end with a cap locknut (Figure 3).
4. Use a cable tie to secure the control cables to the left
handle below the bag support rod.
2
Installing the Starter Rope
No Parts Required
Procedure
Pull the starter rope through the rope guide on the
handle (Figure 4).
1. Starter rope
Note: To make the rope easier to install, squeeze the
control bar on the handle.
Figure 4
2. Rope guide
3
Installing the Fuel Tank
Parts needed for this procedure:
2
Self-tapping screw
1
Fuel tank
Procedure
1. Slide the plastic clips on the front of the fuel tank
onto the fuel tank mount (Figure 5).
1. Plastic clip (2)
2. Secure the bottom of the fuel tank to the fuel tank
bracket by installing the self-tapping screws from
the bottom. Torque the screws to 40 to 50 in-lb
(4.5 to 5.6 N-m).
8
Figure 5