Download Print this page

Troubleshooting - HPI Racing PULSE 4.6 Buggy Instruction Manual

Advertisement

Troubleshooting

Problem
The vehicle does not move
The vehicle does not follow your driving
inputs
The front and rear wheels rotate in
opposing directions
Engine does not start
Engine starts and then stalls
Engine running, but car will not move
Fuel leaking into vehicle
Cause
Transmitter or receiver is off
Batteries are not placed correctly in
the transmitter
Transmitter or receiver is off
Transmitter or receiver aerial is not
fully extended
Some one else is using the same
frequency as you
Incorrect user differential placement
Out of fuel
Air Filter is blocked
Glow Plug igniter not charged
Engine Flooded
Glow Plug is damaged
Throttle isn't adjusted properly
Pull Start Broken
Out of fuel
Air Filter is blocked
Idle speed is set too low
Engine Overheated
Clutch problem
Throttle isn't adjusted properly
Brakes are on
Clutch problem
Receiver battery voltage too low
Gear mesh incorrect
Drivetrain does not turn
Fuel pipe broken
Fuel tank leaking
Exhaust seal leaking
Page 12
Remedy
Turn on both the transmitter and
receiver
Place batteries in the transmitter
properly
Turn on both the transmitter and
receiver
Fully extend both aerials
Change your frequency crystals to
one which no one else around you is
using or wait until the driver of the
same frequency has finished driving
or go to a different place to drive your
vehicle
Insert the differential the correct way
Fill up with fuel and prime the engine
Check Air Filter or replace if
necessary
Charge Glow Plug igniter
Discharge Fuel
Replace Glow Plug
See Turning on the power section
Replace Pull Start
Fill up with fuel and prime the engine
Check Air Filter or replace if
necessary
Adjust the idle speed
Allow engine to cool down and then
restart
Replace Clutch
See Turning on the power section
Check brake setup
Replace Clutch
Replace receiver batteries
Adjust gear mesh
Check for damage
Replace fuel pipe
Replace fuel tank
Replace exhaust seal

Advertisement

loading