Changing The Engine Oil And Filter - Toro 09200 Operator's Manual

Table of Contents

Advertisement

1. Wash the foam pre-filter in liquid soap and warm
water. When clean, rinse it thoroughly.
2. Dry the pre-filter by squeezing it in a clean cloth (do
not wring).
3. Put one or two ounces of oil on the pre-filter
(Figure 45).
1. Foam element
4. Squeeze the pre-filter to distribute the oil.
5. Inspect the paper filter for tears, an oily film, and
damage to the rubber seal (Figure 46).
1. Paper element
Important: Never clean the paper element.
Replace the paper element if it is dirty or
damaged (i.e., after approximately 100 operating
hours).
Installing the Filters
Important: To prevent engine damage, always
operate the engine with the complete foam and
paper air cleaner assembly installed.
1. Carefully slide the foam pre-filter onto the paper
filter (Figure 46).
2. Place the air cleaner assembly onto the air cleaner
base (Figure 44).
3. Install the cover, spacer and secure it with the cover
nut (Figure 44). Torque the nut to 95 inch-lb (11
N-m).
4. Install the air cleaner cover and secure with the knob
(Figure 44).
Figure 45
2. Oil
Figure 46
2. Rubber seal
Changing the Engine Oil and
Filter
Service Interval: After the first 50 hours
Every 100 hours—Change the engine
oil and filter.
Note: Change oil and filter more frequently when
operating conditions are extremely dusty or sandy.
Oil Type: Detergent oil (API service SJ, SK, SL, SM or
higher)
Crankcase Capacity: w/filter, 2.0 qt. (1.9 l)
Viscosity: See table below
1. Start the engine and let it run for five minutes. This
warms the oil so it drains better.
2. Park the machine so that the drain side is slightly
lower than the opposite side to ensure that the oil
drains completely.
3. Set the parking brake, stop the engine, and remove
the key.
4. Place a pan below the oil drain. Remove the oil drain
plug to allow oil to drain.
5. When the oil has drained completely, replace the
plug.
Note: Dispose of the used oil at a certified recycling
center.
6. Place a shallow pan or rag under the filter to catch
oil (Figure 48).
36
Figure 47

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procore 648

Table of Contents