Replacing The Grass Deflector - Toro 74413 Operator's Manual

Contact with a sharp blade can cause serious
injury.
Wear gloves or wrap sharp edges of the
blade with a rag.
1. Hold the blade end using a rag or
thickly-padded glove.
2. Remove the blade bolt, spring disk and blade
from the spindle shaft (Figure 68).
Sharpening the Blades
When sharpening blade, pieces of blade
could be thrown and cause serious injury.
Wear proper eye protection when sharpening
blade.
1. Use a file to sharpen the cutting edge at both
ends of the blade (Figure 66). Maintain the
original angle. The blade retains its balance if
the same amount of material is removed from
both cutting edges.
Figure 66
1. Sharpen at original angle
2. Check the balance of the blade by putting it on
a blade balancer (Figure 67). If the blade stays
in a horizontal position, the blade is balanced
and can be used. If the blade is not balanced,
file some metal off the end of the sail area only
(Figure 68). Repeat this procedure until the
blade is balanced.
Figure 67
1. Blade 2. Balancer
Installing the Blades
1. Install the blade onto the spindle shaft
(Figure 68).
Important: The curved part of the blade
must be pointing upward toward the inside
of the mower to ensure proper cutting.
2. Install the spring disk and blade bolt. The
spring disk cone must be installed toward the
bolt head (Figure 68). Torque the blade bolt to
85-110 ft-lb (115-150 N•m).
Figure 68
1. Sail Area of Blade
2. Blade
3. Spring Disk
Replacing the Grass
Deector
An uncovered discharge opening could
allow the lawn mower to throw objects in
the operator's or bystander's direction and
result in serious injury. Also, contact with
the blade could occur.
• Never operate the lawn mower unless
you install a cover plate, a mulch plate, or
a grass chute and catcher.
• Make sure the grass deflector is in the
down position.
1. Remove the locknut, bolt, spring and spacer
holding the deflector to the pivot brackets
(Figure 69). Remove the damaged or worn
grass deflector.
50
4. Blade Bolt
5. Cone Towards Bolt Head