Assembling And Unfolding The Handle - Toro 20053 Operator's Manual

Setup
Important: Remove and discard the protective
plastic sheet that covers the engine.
1. Assembling and Unfolding
the Handle
Assembling and unfolding the handle improperly
can damage the cables, causing an unsafe operating
condition.
•
Do not damage the cables when assembling and
unfolding the handle. Ensure that you do not get
the cables caught between the handle halves and
that they run to the inside of the handles.
•
If a cable is damaged, contact an Authorized
Service Dealer.
1. Remove the upper handle knobs and bolts from the
upper handle ends.
2. Carefully move the upper handle forward and place the
ends over the lower handle so they are in line and nest
together; (Figure 3).
Figure 3
3. Install the bolts and upper handle knobs with the knobs
on the outside of the handle, tightening the knobs as
tight as you can (Figure 4).
Figure 4
4. Rotate the handle rearward (Figure 5).
Figure 5
5. Attach the handle brackets (Figure 6) to the lower
handle sides.
Figure 6
1. Handle bracket (2)
6. Pull the starter rope through the rope guide on the
handle (Figure 7).
4