Step
1
Removing the Shipping
Bracket and Shipping
Washers
No Parts Required
Procedure
1. Remove the center gage wheel nut, 2 large
washers, angle bracket, and 1 small washer
(Figure 2). Discard the 2 large washers and the
angle bracket.
Figure 2
1. Center Gage Wheels and
Spacer
2. Nut
3. Large washer-discard
2. Install the center gage wheels with the
previously removed bolt, spacer, small washer,
and nut (Figure 3).
4. Angle bracket-discard
5. Small washer
1. Center Gage Wheels and
Spacer
2. Nut
3. Bolt
Step
2
Installing the Handle
Assembly
Parts needed for this step:
1
Handle assembly
2
Flanged bolt (3/8 x 1 inch)
2
Flanged bolt (3/8 x 1-1/4 inches)
4
Flange nut (3/8 inch)
Procedure
1. Align handle with upper mounting holes in
rear frame (Figure 4).
2. Secure the handle at each upper mounting hole
with a flange bolt (3/8 x 1-1/4 inches) and
flange nut (3/8 inch) (Figure 4).
3. Select the low position for the lower mounting
hole (Figure 4).
4. Secure the handle at each lower mounting hole
with a flange bolt (3/8 x 1 inch) and flange nut
(3/8 inch) (Figure 4).
Note: The handle position can be adjusted to
match the operator's height preference.
13
Figure 3
4. Washer
5. Spacer