Adjusting The Level - Samsung RFG293HA User Manual

Setting up your French Door Refrigerator

ADJUSTING THE LEVEL

Make sure the refrigerator is level so that you can make final adjustments. Use a level to test if the refigerator
is level both side to side and back to front. If the refrigerator is not level, it will not be possible to get the doors
perfectly even, which may cause moisture condensation and increased energy bills. Below is an example of how
to level the refrigerator if the left side of the refrigerator is lower than the right side.
How to adjust the level
1. Open the freezer drawer and remove the lower basket. (See to page 11)
2. Remove the two screws (
3. Remove the cover leg front (
4. Insert a flat-blade screwdriver (-) into a notch on the left control lever, and turn it count clockwise to level
the refrigerator. (You turn the lever clockwise to lower the refrigerator and counterclockwise to raise it.)
flat-blade screwdriver(-)
Both control levers must be touching the floor to avoid possible personal injury or property damage because of
tipping.
CAUTION
If the right side is lower, perform the same procedure, but with the right control lever.
It is difficult to remove the cover leg front from the refrigerator, so we do not recommend making small adjustments
wIth the control lever. Instead, refer to the next page for the best way to make minor adjustments to the doors.
DA68-01926A-11.indb 15
) attached to the cover leg front (
1
2
) by lifting the bottom part of the cover leg front up and pulling it out.
2
Control Lever
) with a Philips screwdriver(+).
2
1
Control Lever flat-blade screwdriver(-)
Setting Up _15
13. 12. 2. 5:25