Checking And Adjusting The Shift Lever Plate; No Parts Required - Toro 30092 Operator's Manual

1. Bolt, (5/16 x 7/8 inches)
2. Lock washers, (5/16 inch)
3. Washer, (5/16 inch)
4. Fuel line
5. Hose clamp
3
Checking and Adjusting the
Shift Lever Plate

No Parts Required

Procedure
1. Shift lever to second gear and check alignment
of lever in slot of shift lever plate. The clearance
between top and bottom of the shift lever should
be equal (Figure 7).
2. If clearance is not correct, remove lever and bend it
slightly to adjust (Figure 7).
Note: Do not bend lever while it is attached to the
transmission shaft or damage may occur.
Figure 6
6. Stud
7. Spring
8. Locknut
9. Shift lever plate
10. Fuel tank connection
1. Shift lever
2. Shift lever plate
3. Rubber seal washer
3. Shift lever to neutral and check alignment of lever in
slot of shift lever plate. The clearance on the sides of
shift lever should be equal (Figure 7).
4. If clearance is not correct, loosen shift lever plate and
adjust it side-to-side. Tighten the shift lever plate.
Note: Tighten left side of the fuel tank until it is
completely tight and then unscrew locknut one full
turn. This will allow the spring to work.
1. Shift lever in 2nd gear
2. Shift lever plate
12
Figure 7
4. Square hole washer
5. Spring washer
6. Locknut, (3/8 inch)
Figure 8
3. Shift lever in neutral
position
4. Equal distance