Table of Contents
Advertisement
Do you print data without margins?
●
This symptom occurs if a margin is set to none in the printer driver. The marginal areas within the first 5
mm from the respective edges of paper are not printable (for envelopes, the top and bottom marginal
areas within the first 10 mm from the top/bottom edge are not printable). Make sure to have margins
around the document to print.
[Finishing] tab
Are you using custom size paper loaded in correct orientation?
●
Load the custom size paper in landscape orientation when you print without using the UFR II printer
driver.
●
Load the custom size paper in portrait orientation if the following conditions are met when you are using
the UFR II printer driver.
Paper Size in Select Feeder Menu <Free Size>
Loaded Paper
Streaks Appear/Printing is Uneven
Have you cleaned the fixing unit?
●
Clean the fixing unit.
Fixing Unit(P. 565)
Is the amount remaining in toner cartridge running low?
●
Check how much toner is left, and replace the toner cartridge as necessary.
Replacing Toner Cartridges(P. 566)
Is it time to replace the toner cartridge?
●
Materials inside the toner cartridge may have deteriorated. Replace the toner cartridge.
How to Replace Toner Cartridges(P. 569)
Are you using the machine in an environment with high humidity?
●
Change the setting of <Special Density Mode>. Selecting <On> may improve the problem.
Special Density Mode(P. 425)
Troubleshooting
[Advanced Settings]
[Expand Print Region and Print]
Long edge length is 215.9 mm or less.
552
[Off]
Advertisement
Table of Contents
