Import/Export Operation - JVC MC-8200LU Instructions Manual

Mail Slot

6-2. Import/export operation

When loading/ejecting discs from any chosen tray by the mail slot without the control of the host computer, follow the proce-
dure shown below.
• During the import/export operation, the host computer commands which include the carrier operations cannnot be ex-
ecuted.
1.
In the normal display mode, press the MODE key.
(The menu display appears.)
2.
Press the SELECT key 7 times.
("8. IMPORT/EXPORT" appears.)
3.
Press the ENTER key.
(Select "8. IMPORT/EXPORT".)
4.
Press and hold the SELECT key for more than 5 sec-
onds.
(Wait until the display starts to blink.)
5.
Release the SELECT key when the input start tray
message is prompted.
6.
Enter the start tray number(001-200*
key pad.
•If the number is wrong, input a new 3-digit tray No.(ex.
001) again.
7.
Press the ENTER key.
8.
Enter the end tray number(001-200*
•If you wish to use the import/export operation for a
single disc, either enter the same end tray number as
the start tray number or press the ENTER key without
entering any number.
9.
Press the ENTER key.
•You can cancel the following operations by pressing
and holding the ENTER key for 5 seconds during the
import/export operation. If the mail slot opens after
cancelling the operation, press the LOAD/EJECT
key.(The tray in operation will be returned to the maga-
zine; then the import/export operation will be com-
pleted.)
* 1 MC-8200LU. (001 - 600 for the MC-8600LU)
Downloaded From Disc-Player.com JVC Manuals
1
) using the 10-
1
) using the 10-key pad.
1 . N O R M A L D I S P L A Y
2 . E R R O R D I S P L A Y
8 . I M P O R T / E X P O R T
9 . D R I V E D I S P L A Y
P U S H S E L . K E Y
I M P O R T / E X P O R T
P U S H S E L . K E Y
I M P O R T / E X P O R T
I N P U T S T A R T
T R A Y N o . : – – –
I N P U T S T A R T
T R A Y N o . :
I N P U T E N D
T R A Y N o . : – – –
I N P U T E N D
T R A Y N o . :
I M P O R T / E X P O R T
T R A Y N o . : 1 1 5
F O R
F O R
1 1 5
1 2 4