Yamaha CDR-HD1000 Service Manual page 8

CDR-HD1000
QQ
3 7 63 1515 0
HDD replacement
• The HDD must be replaced as a unit. None of its
components can be supplied separately.
• When replacing the HDD, write down the following
items.
• Serial No. of the product and the symptom in detail
• Mechanical serial No./mechanical shipping serial
No. of the HDD
• After replacing the hard disc, be sure to initialize it using
the "HDD format" procedure on page 13.
1. Removal of HDD Unit
a. Disconnect the power cable and IDE cable from the
HDD unit. (Fig. 7)
b. Remove 4 screws (9) and then remove the holder.
(Fig. 8)
c. Take out the HDD unit. (Fig. 8)
2. Disassembly of HDD Unit
a. Take out the HDD unit from the case. (Fig. 8)
b. Remove 4 screws (0) and then remove the plate. (Fig.
8)
c. Remove 4 screws (A) and then remove the mounter.
(Fig. 8)
3. Assembly of HDD
a. Insert the jumper pin of the new HDD unit at the master
TE position.
L 13942296513
b. Install the mounter with 4 screws (A). (Fig. 8)
c. Install the plate with 4 screws (0). (Fig. 8)
d. Enclose the HDD unit with the case. (Fig. 8)
4. Installation of HDD Unit
a. Connect the power cable and IDE cable to the HDD
unit. (Fig. 7)
b. Put the HDD unit in place. (Fig. 8)
c. Using 4 screws (9), install the holder. (Fig. 8)
www
.
7
http://www.xiaoyu163.com
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
Power Cable
9
0
Q Q
3 6 7 1 3 1 5
co
.
9 4 2 8
IDE Cable
HDD Unit
Fig. 7
Holder
9
Plate
0
HDD
Mounter
0 5 8 2 9 9 4 2 8
A A
Case
Fig. 8
m
9 9
9 9