Table of Contents
Advertisement
Board selection by the supplied utilities
The three supplied utilities – LCIC-WIM-CALIBRATION, LCIC-WIM-
SETTINGS & LCIC-WIM-MONITOR – enable easy selection of the
required board:
• Upon program start, all detected addresses are reported. Verify that
the total number of boards detected (reported at the bottom of the
display) corresponds the real number. It might occur that the
automatic detection fails to detect a board. If you know that some
board does exist although it was not detected, click its address
manually. Finally, select the board that will be activated first by
right-clicking its address (or leave the default selection) and click
'Continue' (or just wait).
• When you are accessing some board, usually you may switch to
another one. (In the LCIC-WIM-CALIBRATION this option is
available only in step 1.) In order to switch the active board, right
click the mouse. You'll get a list of all existing boards, with the
active one dimmed and checked. You may select another board to
be activated by clicking its address.
66
Advertisement
Table of Contents
