Troubleshooting - Omega Engineering 8 Channel Thermocouple USB Data Acquisition Module TC-08 User Manual

3.5

Troubleshooting

The following table lists each of the error codes described in the
usb_tc08_get_last_error
what to do in the event of a particular error occurring.
Error code Description
1
2
3
4
5
6
7
8
9
10
11
12
13
14
Key
S Errors in this category indicate that a fault has occurred with the USB
TC-08 unit or your PC. Try disconnecting the USB TC-08, then
reconnecting it. If this does not work, restart your PC. If this does not
work, do the following:
1. Uninstall the software and restart the PC
2. Reinstall the software and restart the PC
3. If this does not work, download the latest version of the software
from
4. If this does not work, contact
P Errors in this category are handled internally within software
applications, and only developers need to be aware of their meanings.
Find a
Errors in this category are user-dependent and developers should make
P* sure that their application provides suitable error messages for users to
read in the event of an error occurring.
section, and divides them into categories, so that you know
USBTC08_ERROR_OS_NOT_SUPPORTED
USBTC08_ERROR_NO_CHANNELS_SET
USBTC08_ERROR_INVALID_PARAMETER
USBTC08_ERROR_VARIANT_NOT_SUPPORTED
USBTC08_ERROR_INCORRECT_MODE
USBTC08_ERROR_ENUMERATION_INCOMPLETE
USBTC08_ERROR_NOT_RESPONDING
USBTC08_ERROR_FW_FAIL
USBTC08_ERROR_CONFIG_FAIL
USBTC08_ERROR_NOT_FOUND
USBTC08_ERROR_THREAD_FAIL
USBTC08_ERROR_PIPE_INFO_FAIL
USBTC08_ERROR_NOT_CALIBRATED
USBTC08_ERROR_PICOPP_TOO_OLD
http://www.omega.com
routine which fails with one of these error codes.
and install this, then restart the PC
das@omega.com
Technical reference
Category
P*
P
P
P*
P
S
S
S
S
S
S
S
S
S
43