Table of Contents
Advertisement
INSTALLATION
A WIRING DIAGRAM IS ENCLOSEDIN THE ENVELOPE
Clearance Dimensions
WITH THIS BOOKLET; ALSO THERE IS A DIAGRAM
GLUED TO THE UNIT, BEHIND CONTROL PANEL.
For completeinformationin regard to the installationof wall
ovens and clearancessee the installationdrawings.
Check the oven model number plate to see if the oven is
approved for installation in mobile homes and/or
recreationalvehicles. If approved the following items are
Locating The Unit
applicable.NOTE: Oven model number plate is locatedon
bottom of control panel lower trim.
The installationdrawing,gives the minimum dimensionsof
the cabinet cut-out for the oven and the location of the gas
and electricaloutlets.Thedimensionsgiven arefor the oven
Mobile Homes
bottom to be a minimum of 12" inches abovethe floor. The
The installation of an oven designed for mobile home
recessinwhichtheovenistobeinstalledshouldhaveasolid
installation must conform with the Manufactured Home
floor and be so constructed as to provide a complete
Constructionand Safety Standard,Title 24 CFR, part 3280
enclosure around the recessed portion of the oven to
(formerly The Federal Standard for Mobile Home
prevent drafts which may result in inconsistent and
Constructionand Safety,Title 24, HUD part 280) or, when
unsatisfactory burner and baking performance,it should be
such standard is not applicable, the Standard for
perfectly level to provide a solid, level foundation for the
ManufacturedHomeInstallation,ANSIA225.1/NFPA501A,
oven unit. The openingsin the enclosurefor gasand electric
service shouldbe sealed beforethe oven is installed. Airfor
or with local codes,
combustionenters at the extremebottom of front panel.Do
InCanadathe oven mustbe installedin accordancewith the
not block or obstruct this opening.
current CSA Standard C22.1 - Canadian Electrical Code
Part 1and Section Z240.4.1- InstallationRequirementsfor
For SAFETY CONSIDERATIONS fasten the oven to the
Gas Burning Appliances in Mobile Homes (CSA Standard
cabinet with the four (4) screws (shipped with the unit)
CAN/CSA- Z240MH).
through the holes in the trim behindthe oven door. The unit
should be leveled properly before being secured to the
cabinet.
Recreational Vehicles
The installation of an oven designed for recreational
vehicles must conform with state or other codes or, in the
absence of such codes, with the Standard for Recreational
Vehicles, ANSI A119.2-latestedition.
In Canadathe oven must be installed in accordance with
CAN/CSA - Z240.6.2 - Electrical Requirementsfor R.V.'s
(CSA Standard CAN/CSA - Z240 RV Series) and Section
Z240.4.2
Installation Requirements for
Propane
Appliances and Equipment in R.V.'s (CSA Standard
CAN/CSA- Z240 RV Series).
-4-
Advertisement
Table of Contents
