Table of Contents
Advertisement
Available languages
Available languages
To install the camera side on a pipe
1
Pull the power and video cables
through the pipe connection hole
on the camera side.
1. Remove the side cover from the
Case using a coin or minus (-) driver.
(Rotate counterclockwise.)
2. Push the power and video cables
stretched outside of the bottom hole
into the Case. And pull them out from
the side cover of the Case.
2
Attach the removed side cover to the bottom hole and
rotate it clockwise using a coin or minus (-) driver.
(Be sure to insert the O-ring (P22 T2.4) into the hole before
assembly. The ring is necessary for waterproofing.)
16_
Installation and Connection
Advertisement
Chapters
Table of Contents
