Assistance; Installation - Indesit DFP 58T1 Operating Instructions Manual

Advice regarding the first wash cycle
After the installation, remove the stoppers from the racks and
the retaining elastic elements from the upper rack (if any).
Water softener settings
Before starting the first wash cycle, set the hardness lev-
el of
the water from the mains supply. (see chapter Rinse
aid and refined salt).
First load the softener tank with water, then introduce about
1 kg of salt. It is perfectly normal for water to flow out.
As soon as this procedure is complete, run a wash cycle.
Only use salt that has been specifically designed for dish-
washers.
After the salt has been poured into the machine, the LOW
*
SALT indicator light switches off.
If the salt container is not filled, the water softener and the
heating element may be damaged as a result.
Technical data
width 60 cm
Dimensions height 85 cm
depth 60 cm
Capacity 14 standard place-settings
0,05 ÷ 1MPa (0.5 ÷ 10 bar)
Water supply pressure
7,25 – 145 psi
Power supply voltage See appliance data plate
Total absorbed power See appliance data plate
Fuse See appliance data plate
This dishwasher conforms to the
following European Community
Directives:
-2006/95/EC (Low Voltage)
-2004/108/EC (Electromagnetic
Compatibility)
-2009/125/EC (Comm. Reg.
1016/2010) (Ecodesign)
-97/17/EC (Labelling)
-2012/19/EU Waste Electrical
and Electronic Equipment
(WEEE)
The machine has a buzzer/set of tones
dishwasher model
) to inform the user that a command has
been implemented: power on, cycle end etc.
The symbols/indicator lights/LEDs on the control panel/
display may vary in colour and may have a flashing or fixed
(depending on the dishwasher model)
light
The display provides useful information concerning the type
of wash cycle, drying/wash-cycle phase, remaining time,
temperature etc etc.
EN

Assistance

Before contacting Assistance:
• Check whether the problem can be resolved using the
Troubleshooting guide (see Troubleshooting).
• Restart the programme to check whether the problem has
ceased to exist.
• If the problem persists, contact the Authorised Technical
Assistance Service.
Never use the services of unauthorised technicians.
Please have the following information to hand:
• The type of malfunction.
• The appliance model (Mod.).
• The serial number (S/N).
This information can be found on the appliance data plate (see
Description of the appliance) .
*
Only available in selected models.
(depending on the
EN
.
9