11
SERVICE WORK ON THE CHASSIS
11.45
Changing the hydraulic clutch fluid
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
102195-10
–
Fill bleeding syringe
Bleed syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
On the clutch slave cylinder, remove bleeder screw
syringe
Info
Clean up overflowed or spilt brake fluid immediately with water!
102196-10
Avoid contact between brake fluid and painted parts. Brake fluid attacks
paint!
Use only clean brake fluid from a sealed container!
–
Inject the liquid into the system until it escapes from drill hole
cylinder without bubbles.
–
Drain fluid occasionally from the master cylinder reservoir, to prevent overflow.
–
Remove the bleeding syringe. Mount and tighten screws bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container rim
–
Position the cover with the membrane. Mount and tighten the screws.
102197-10
.
with membrane
.
with the appropriate hydraulic fluid.
p. 102)
.
and mount bleeding
of the master
4 mm (0.16 in)
59