IKEA HOGKLASSIG Manual page 18

ENGLISH
Problem
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
The hob deactivates.
The power setting changes
between two levels.
The symbols become
hot.
There is no signal when you
touch a symbol on the con-
trol panel.
The flexible induction cook-
ing area does not heat up
the cookware.
comes on.
Possible cause
STOP+GO function operates. Refer to "Daily use" chapter.
There is water or fat stains
on the control panel.
You put something on one or
more symbols.
You put something on the
symbol
Power exchange function
operates.
The cookware is too large or
you put it too near to the
controls.
The signals are deactivated. Activate the signals.
The cookware is in the
wrong position on the flexi-
ble induction cooking area.
The diameter of the bottom
of the cookware is incorrect
for the activated function or
function mode.
Automatic Switch Off oper-
ates.
Remedy
Clean the control panel.
Remove the object from the
symbols.
Remove the object from the
symbols.
Refer to "Daily use" chapter.
Put large cookware on the
rear zones if possible.
Refer to "Daily use" chapter.
Place the cookware in the
correct position on the flexi-
ble induction cooking area.
The position of the cookware
depends on the activated
function or function mode.
Refer to "Flexible induction
cooking area" chapter.
Use cookware with diameter
applicable to the activated
function or function mode.
Use cookware with diameter
smaller than 160 mm on a
single section of the flexible
induction cooking area.
Refer to "Flexible induction
cooking area" chapter.
Deactivate the hob and acti-
vate it again.
18