Controls & Features - Cub Cadet Z-Force L Operator's Manual

Controls & Features
Cup Holder
Fuel Tank Cap
Fuel Level Window
LH Transmission Bypass Rod
NOTE: This Operator's Manual covers several models. Tractor
features may vary by model. Not all features in this manual are
applicable to all tractor models and the tractor depicted may
differ from yours.
NOTE: References to LEFT, RIGHT, FRONT, and REAR indicate that
position on the tractor when facing forward while seated in the
operator's seat.
RH and LH Drive Control Levers
The RH and LH control levers are located on each side of the
operator's seat. These hinged levers pivot outward to open
space to permit the operator to either sit in the tractor seat, or to
dismount the tractor. The levers must be fully opened out and in
the neutral position to start the tractor engine. When the levers
are fully outward, the parking brake is also engaged.
Each lever controls the respective RH or LH transmission.
Consequently, these levers control all of the movements of the
tractor. Driving and steering utilizing these control levers is quite
different from conventional tractors, and will take some practice
to master. Refer to Operation for instructions on using the control
levers.
12
LH Control Lever
Ignition Switch
The ignition switch is located on the RH console
to the rear of the throttle or throttle/choke
control lever. The ignition switch has three
positions as follows:
STOP
RUN
START
the key immediately when the engine starts
NOTE: To prevent accidental starting and/or battery discharge,
remove the key from the ignition switch when the tractor is not
in use.
RH Control Lever
RH Transmission Bypass Rod
— The engine and electrical system is turned off.
— The tractor electrical system is energized.
— The starter motor will turn over the engine. Release
4
Deck Lift Handle
Deck Height Index
Throttle Control
Choke Control
LCD Service Minder
& Hour Meter
PTO Knob
Ignition Switch