Instrument Lighting Dimmer; Headlamp Exit Delay; Daytime Running Lamps; Automatic High Beam Control - Ford 2015 Focus Owner's Manual

INSTRUMENT LIGHTING
DIMMER
Note: If the battery is disconnected,
discharged, or a new battery is installed, the
dimmer will set the illuminated components
to the maximum setting automatically.
Press repeatedly or press and hold until
the desired level is reached.

HEADLAMP EXIT DELAY

After you switch the ignition off, you can
switch the headlamps on by pulling the
direction indicator lever toward you. You
will hear a short tone. The headlamps will
switch off automatically after three
minutes with any door open or 30 seconds
after the last door has been closed. You
can cancel this feature by pulling the
direction indicator toward you again or
switching the ignition on.
Focus (CEW) Vehicles Built From: 16-02-2015, CG3630en enGBR, Edition date: 01/2015, First Printing
Lighting

DAYTIME RUNNING LAMPS

Always remember to switch your
headlamps on in low light situations
or during inclement weather. The
system does not activate the tail lamps
and may not provide adequate lighting
during these conditions. Failure to activate
your headlamps under these conditions
may result in a collision.
To switch the system on:
1. Switch the ignition on.
2. Switch the lighting control to the off or
autolamp position.
AUTOMATIC HIGH BEAM
CONTROL
The system does not relieve you of
your responsibility to drive with due
care and attention. A manual
override may be necessary if the system
fails to switch the high beam on or off.
A manual override may be required
when approaching other road users
such as cyclists.
Do not use the system in fog.
In cold and severe weather
conditions the system may not
function. A manual override may be
necessary in these cases.
The system may not deactivate the
high beam if the lights of oncoming
vehicles are hidden by obstacles (for
example guard rails).
59
WARNING
WARNINGS