Omega OMB-DAQBOARD-3000 Series User Manual page 93

Using the Screw-Terminal Blocks
You must remove the DBK215 module's cover plate to access the screw terminal blocks.
This is described in steps 1 and 2 below.
1. Remove the top inward screws from each of the 4 mounting brackets. See following figure.
2. After the 4 screws have been removed, carefully remove the cover plate.
3. As soon as the DBK215 cover is removed, verify that the Host Power LED is "Off."
4. Make the wiring connections to the terminals. Refer to the board's silkscreen and to
5. Tighten the terminal block screws snug; but do not over-tighten.
6. After all terminal connections are made and verified correct, return the cover to the unit and
Appendix A
To remove the cover plate you
must first remove the top
inward screw from each of the
4 mounting brackets.
The Cover Plate is Secured by 4 Srews
See following figure for location.
Host Power LED Location
the pin correlations on the next few pages.
secure in place with the 4 screws removed earlier. Tighten snug, but do not over-tighten.
948894
[2 Screws per-side]
DBK215 A-5