Configuring Video Loss Settings - Lorex LHV2000 Series Instruction Manual

15 Using the Main Menu
7. To configure a schedule when motion detection will be enabled on this channel, click
Setup next to Period. Configure times when motion detection will be enabled. For ex-
ample, you may want to disable motion detection during business hours and enable it
outside of business hours. Click OK when finished.
NOTE
This setting can override scheduled motion recording. This means that motion recording will only
take place at times that are enabled both in the Schedule menu and here.
8. Configure the following system actions when motion is detected:
• Show Message: Check to enable an on-screen pop-up when one of your cameras
detects motion. On-screen pop-up shows the channels an event occurred on and
the type of event.
• Send Email: Check to enable email alerts. You must configure email alerts before
you will be able to receive them (see 15.3.5 Configuring Email Alerts, page 59).
• PTZ Activation: If you have PTZ cameras, check to set up your PTZ cameras to
move to a specified preset when the camera detects motion. Click Setup to select
the PTZ cameras you want to activate and specify the preset point each one will
move to.
• Record Channel: Select the channels that will record when motion is detected on
the selected channel.
• Buzzer: Check to enable the system buzzer.
• Snapshot: Check to save a snapshot when the camera detects motion.
9. Click OK to save changes.
NOTE
Click Test to view a live view of the camera and see which areas of the screen trigger for motion. Areas
where motion is detected will change color.

15.3.8 Configuring Video Loss Settings

Video Loss occurs if the system loses connection to one of the cameras.
To configure Video Loss settings:
1. From the Main Menu, click
2. Under Channel, select the channel you would like to configure.
3. Check Enable to enable video loss events for the selected channel.
#LX400060; r.35927/36038; en-US
and then click Event>Motion>Video Loss.
63