Reverse The Door Swing - 323 Models (Optional) - Norcold 323 Installation Manual

Reverse the Door Swing - 323 Models (optional)

This refrigerator has a door hinge that allows you to change the direction that the door opens. You can change the door swing at any
time, but the best time is before you install the refrigerator. To change door swing:
1. Remove the door (See Art00949):
- Turn out and save the upper hinge pin [63].
- Open the door [39] a small amount and pull the top of the door away from the upper hinge
of the refrigerator.
- Lift the door off of the lower hinge pin [64].
- Turn out, remove, and save the lower hinge pin.
2. Change the position of the hinges (See Art00950):
- Carefully pull the breaker [232] off the front of the refrigerator.
- Remove the screws [41] from the hinge [235] and the hinge spacer [236].
- Invert the hinge and the hinge spacer and put them on the other side of the refrigerator
- Attach the hinge and the hinge spacer with the screws.
3. Install the door:
- Turn the lower hinge pin down into the hinge.
- Invert the breaker and push it onto the front of the refrigerator.
- Put the door down onto the lower hinge pin.
- Close the door.
- Align the holes in the hinge and the door and hold in this position.
- Turn the upper hinge pin down into the hinge and into the door.
4. Examine the door:
- Make sure the door aligns correctly.
- Make sure the travel latch engages correctly.
Installation Manual 6
39
64
Art00949
236
41
232
232
41
Art00950
63