Setting The Recording - Samsung XRN-2010 User Manual

Network video recorder

Table of Contents

menu setup

If the new resolution does not fit the monitor, the output will not be displayed normally. In this case, wait until the monitor

returns to the default resolution and then change to a different resolution.

Specify the event display time and dwell time in consideration of the video delay depending on the network environment.

You can configure the settings of the profile used to display the live image on the expansion monitor in "Live Streaming".

Please refer to "Live Streaming". (Page 47)

Live display of the expansion monitor supports up to 1280 X 720 resolution.

To adjust the display position

Some monitors many not display information (camera name, icon, time information, etc.) about the NVR,

depending on the condition. Then, you can change the display position of the data.

FULL

RAID

SCSI

1. From the monitor setup menu, select <Display Position Setup>.

2. Using the number button to adjust the screen that is cut off.

3. Press <OK>.

Text

Device and events can be set up.

Device Settings

Relevant values of a device connected to NVR can be set.

• Device : Enter the user's desired name

• Use : Select whether or not to use

• CH : Select a channel to add a device from a channel table.

• Port : Display a port number that is set

40_ menu setup

• Encoding type : Select an encoding type to use from a list.

- You can select starting and ending character strings.

General characters, special characters, and Hex codes (e.g. 0x12, 0x34) can be used for character strings.

Equipment connected to NVR uses TCP/IP communication protocol.

Event Settings

You can set up event keywords.

• Total amount : Set a total amount condition to receive alarms.

• Keyword : If the <Add> button is clicked, a screen to add keywords pops up. If you select one of the added

keywords to delete and click the <Delete> button, the selected keyword will be deleted.