Duress Code; Switch On/Off Receivers; Remote Maintenance (Optional) - Honeywell GKP-S8M User Manual

Duress code

Use a duress code if you are forced to disarm your security
system under duress. Your duress code is obtained by adding 1
to the last digit of your code (e.g. 1234 => 1235, 6789 => 6780).
The system will disarm as normal but a silent alert signal is
transmitted to your alarm company (depending on the
configuration).

Switch on/off receivers

Note: This function is optional, and can be set at installation.
It is possible to switch on/off receivers (such as smart plugs) from
the keypad.
To switch a receiver on/off:
1. Press the
key to switch the selected receiver off.
2. Select the desired receiver by pressing a key corresponding to
the receiver number 0 to 9 (0 corresponds to receiver number
10).
A high beep is played if the receiver is driven successfully;
otherwise a low beep is played.

Remote Maintenance (optional)

Note: This function is optional and depends on the panel
configuration.
Press the
maintenance function as configured by your installer. Ask your
installer for more information on this function.
key to switch the selected receiver on or the
+ keys simultaneously to activate the remote
7