Chapter 2 — Scanning With the SR61T
Understanding the Lights
Intermec Ready-to-Work Indicator
12
The SR61T uses the Intermec Ready-to-Work™ light and Status light
to communicate information about your scanner. The lights
described in this section are new and do not correspond to the legacy
SR61T models (SR61TV, SR61TA, SR61TL or SR61TE).
Note: If you prefer to use the legacy beep and LED mode you can
activate the legacy mode using EasySet. For information on using
EasySet see
Chapter 4, "Configuring the SR61T" on page 31
The Intermec-Ready-to-Work indicator™ (blue LED) indicates that
the scanner is ready to scan bar codes. This light stays on all the time
when the scanner is ready to work however your scanner will also flash
status information using green and red lights. See the Status Light
information in the next section.
Blue Intermec Ready-to-Work Indicator
Light State
Off
On
Note: By default the Intermec Ready-to-Work light is enabled however
you can disable the light if desired. You can also change the color. See
EasySet version 5. 6. 5. 4. for more information.
What it Means
Scanner is not ready to scan bar codes.
The SR61T is ready to scan bar codes.
SR61T Tethered Scanner User's Guide