Sony XAV-A1 Service Manual page 11

Connecting without optional TV tuner unit (Except Russian)
RCA interconnects
(optional)
Active subwoofer
(optional)
SUB OUT (MONO)
RCA interconnects
(optional)
Rear speakers
(optional)
REAR L/R
Amplifiers
RCA interconnects
(optional)
(optional)
To the optional
back camera or a
Front speakers
video equipment
(optional)
FRONT L/R
RC-104 (optional)
digital output
White
Left
White/black
Front speakers
From car antenna
(optional)
Gray
Right
Gray/black
Green
Left
Green/black
Rear speakers
(optional)
Purple
Right
Purple/black
To a metal surface of the car *2
To the +12 V power terminal which is
energized at all times *1
To the +12 V power terminal which is
energized in the accessory position of
the ignition key switch *1*3
To a car's illumination signal *1
Protection device
To the + 12 V power terminal of the
back lamp lead of car
To AMP REMOTE IN of an optional
power amplifier *4
Max. supply current 0.3 A
To the power antenna control lead or
power supply lead of antenna booster
Max. supply current 0.3 A
amplifier *3*5
Parking brake switch lead of car
Tap 9
*1 Be sure to connect the black ground lead to it first.
*2 First connect the black ground lead, then connect the yellow and red power input leads.
*3 When your car has built-in FM/AM antenna in the rear/side glass, see "Notes on the control and power
supply leads" (page 7).
*4 This connection is only for amplifiers. Connecting any other system may damage the unit.
*5 It is not necessary to connect this lead if there is no power antenna or antenna booster, or with a manually-
operated telescopic antenna.
Note on the accessory power input lead (red)
If there is no accessory position, connect to the +12 V power (battery) terminal which is energized at all times.
Connecting without optional TV tuner unit (Russian only)
RCA interconnects
(optional)
Active subwoofer
(optional)
SUB OUT (MONO)
RCA interconnects
(optional)
Rear speakers
(optional)
REAR L/R
Amplifiers
RCA interconnects To the optional
(optional)
(optional)
back camera or
video
Front speakers
(optional)
RC-104 (optional)
FRONT L/R
digital output
Aerial adaptor qd
Parking brake
switch lead of car
A AMP REM
Max. supply current 0.3 A
Protection device
To the + 12 V power terminal of the
back lamp lead of car
1 3 5 7
C from the car's speaker connector
C from the car's speaker connector
2 4 6 8
1 Purple Speaker, Rear, Right
2 Ð Speaker, Rear, Right
3 Grey Speaker, Front, Right
4 Ð Speaker, Front, Right
5 White Speaker, Front, Left
6 Ð Speaker, Front, Left
7 Green Speaker, Rear, Left
8 Ð Speaker, Rear, Left
Negative polarity positions 2, 4, 6,
and 8 have striped cords.
5 7
D from the car's power connector
4 6 8
A To AMP REMOTE IN of an optional power amplifier
This connection is only for amplifiers. Connecting any other system may damage the unit.
Warning
If you have a power aerial without a relay box, connecting this unit with the supplied power
supply leads may damage the aerial.
1
(US, Canadian)
To XM tuner (optional)
Connection
box 1
AUX 3
To game AUX 2 Power
etc. supply
leads 2
REAR MONITOR OUT
To rear (for main
unit)
monitor etc.
Black (0.35 m)
Yellow (0.35 m) Fuse (10 A)
Red (0.25 m)
Orange/white (0.25 m)
Purple/White (5m)
Blue/white (0.25 m)
Blue (0.25 m)
Light green (2.5 m)
9
* Note for the aerial connecting
If your car aerial is an ISO (International
Organization for Standardization) type, use the
supplied adaptor to connect it. First connect the
qd
car aerial to the supplied adaptor , then connect
qd
it to the aerial jack of the main unit.
This terminal is not
used in this case.
AUX 3
Power
From car aerial*
supply
AUX 2
To game etc. leads 1
(for main
REAR MONITOR OUT unit)
To rear
monitor etc.
Light green (2.5 m)
Blue/white
Purple/White (5m)
D from the car's power connector
4 Yellow continuous power supply
5 Blue power aerial control
6 Orange/ switched
White illumination power
supply
7 Red switched power supply
8 Black earth
Positions 1, 2, and 3 do not have pins.
See "Power connection diagram"
on next page for details.
Fuse
(10 A)
9
Connecting with optional TV tuner unit (Except Russian)
Film antenna
Antenna cord
Tuner
To the +12 V power
amplifier
terminal which is
unit
energized in the
accessory position of the
ignition key switch. Be
sure to connect the black
ground lead first.
To a metal point
of the car
To the optional back camera
or a video equipment
10
Power connection diagram
Auxiliary power connector may vary depending on the car. Check your car's auxiliary power connector
diagram to make sure the connections match correctly. There are three basic types (illustrated below). You
may need to switch the positions of the red and yellow leads in the car stereo's power connecting cord.
After matching the connections and switched power supply leads correctly, connect the unit to the car's
power supply. If you have any questions and problems connecting your unit that are not converted in
this manual, please consult the car dealer.
A
Auxiliary power connector
Red C
B Red
Yellow
Yellow
4 Yellow switched power supply
7 Red continuous power supply
Connecting with optional TV tuner unit (Russian only)
Film aerial
To the +12 V power terminal which is
Aerial cord
energized in the accessory position of the
ignition key switch. Be sure to connect the
black ground lead first.
Tuner
amplifier
unit
TV tuner unit
To a metal point
of the car XT-V70
(optional)
To the optional back camera
or video
10
XAV-A1
(US, Canadian)
Connection box 1
To XM tuner (optional)
TV tuner unit
XT-V70
(optional)
AUX 3
Red Red
Yellow Yellow
4 Yellow continuous power supply
7 Red switched power supply
Red Red
Yellow
Yellow
the car without ACC position
AUX 3
11