Olympus EVOLT E-300 Advanced Manual page 180

If you encounter problems
Possible cause
The top left part of the picture appears too bright.
When shooting at slow
shutter speeds, noise may
be generated due to a rise
in temperature in the CCD
drive circuit.
Pictures cannot be played back on the monitor.
Pictures are not stored on
the card.
The card error occurs.
No picture is displayed on the TV when connected to the camera.
The video cable is not
connected correctly.
The camera's video
output signal is incorrect.
The TV 's video signal is
incorrect.
The monitor is hard to see.
The brightness is not
adjusted properly.
The monitor is exposed to
direct sunlight.
The computer does not recognize the camera correctly.
The camera's power is
11
turned off.
The USB driver was not
successfully installed.
The camera's PC MODE
is set to CONTROL.
180
Corrective action
Set NOISE REDUCTION to ON before taking
pictures.
NO PICTURE appears on the monitor. Record
pictures.
Refer to "Error codes".
Connect the cable properly according to the
instructions.
Set the video signal according to the region
where used.
Set the TV to the video input mode.
Adjust the brightness of the monitor using the
menu.
Block the sunlight with your hand.
Set the power switch to
Install the OLYMPUS Master.
Set PC MODE to AUTO or STORAGE. When
AUTO is set, the selection screen for USB
connection is displayed every time you connect
the USB cable to the camera.
ON
.
Ref. Page
P. 105
–
P. 174
P. 116
P. 134
–
P. 131
–
–
P. 158
P. 132