Table of Contents
Advertisement
❏
Never disassemble, modify, or attempt to repair
the AC adapter, power cord, printer, and options
by yourself except as specifically explained in the
printer's guides.
❏
Unplug the printer, and refer servicing to qualified
service personnel under the following conditions:
The power cord or plug is damaged; liquid has
entered the printer or the AC adapter; the printer
or the AC adapter has been dropped or the casing
damaged; the printer or the AC adapter does not
operate normally or exhibits a distinct change in
performance. (Do not adjust controls that are not
covered by the operating instructions.)
❏
Do not use with wet hands.
❏
If you plan to use the AC adapter in Germany, the
building installation must be protected by a 10 or
16 amp circuit breaker to provide adequate
short-circuit protection and over-current
protection for this printer.
For United Kingdom, Singapore, and Hong Kong
users
❏
Replace fuses only with fuses of the correct size
and rating.
Safety requirements
Mains plug:
Use a 3-pin mains plug that is registered with the
Safety Authority.
Flexible cord:
Use a double insulated flexible cord that is certified* to
the relevant IEC or BS standards.
Appliance connector:
Use an appliance connector certified* to the relevant
IEC320.
* certified by member of IECEE CB Scheme.
For United Kingdom users
The following safety information applies to the AC
adapter.
❏
Warning: Refer to the rating plate for the voltage
and check that the appliance voltage corresponds
to the supply voltage.
Safety Instructions
3
Advertisement
Table of Contents
