Remote Control - Sony HT-NT5 Operating Instructions Manual

 If there is an obstacle between the
unit and the subwoofer, move or
remove it.
 Locate the unit and the subwoofer as
close as possible.
 Switch the wireless LAN frequency of
any nearby Wi-Fi router or PC to
5 GHz range.
 Switch the network connection of the
TV or Blu-ray Disc Player from
wireless to wired.

Remote Control

The remote control of this system
does not function.
 Point the remote control at the
remote control sensor on the unit
(page 8).
 Remove any obstacles in the path
between the remote control and the
system.
 Replace both batteries in the remote
control with new ones, if they are
weak.
 Make sure you are pressing the
correct button on the remote control.
TV remote control does not work.
 This problem might be solved by
enabling the IR repeater function
(page 54).
Others
The Control for HDMI function does
not work properly.
 Check the connection with the
system (refer to the supplied Startup
Guide).
 Enable the Control for HDMI function
on the TV. For details, refer to the
operating instructions of your TV.
 Wait a while, and then try again. If
you unplug the system, it will take a
while before operations can be made.
Wait for 15 seconds or longer, and
then try again.
 Make sure the devices connected to
the system support the Control for
HDMI function.
 Enable the Control for HDMI function
on the devices connected to the
system. For details, refer to the
operating instructions of your device.
 The type and number of devices that
can be controlled by the Control for
HDMI function is restricted by the
HDMI CEC standard as follows:
– Recording devices (Blu-ray Disc
recorder, DVD recorder, etc.): up to
3 devices
– Playback devices (Blu-ray Disc
Player, DVD player, etc.): up to 3
devices
– Tuner-related devices: up to 4
devices
– Audio system (receiver/
headphone): up to 1 device (used by
this system)
"PRTCT," "PUSH" and "POWER"
flash alternately in the front panel
display.
 Press  (power) to turn off the
system. After the indicator
disappears, disconnect the AC power
cord (mains lead) and make sure
nothing is obstructing the ventilation
holes of the system.
"BT TX" appears in the front panel
display.
 Press RX/TX on the remote control to
switch [Bluetooth Mode] to
[Receiver]. "BT TX" appears if
[Bluetooth Mode] is set to
[Transmitter] (page 52). When you
press RX/TX on the remote control,
[Bluetooth Mode] is switched to
[Receiver] and the selected input
appears in the front panel display.
65
US