Satellite Receiver Control Setting - JVC DR-MV1 Instructions Manual

Satellite Receiver Control Setting

Your unit
Satellite receiver
21-pin SCART cable
Back of unit
2
VCR/DVD
DISPLAY
8
Downloaded From DvDPlayer-Manual.com JVC Manuals
Satellite receiver
Satellite Controller
(provided)
(suggested locations)
Transmitter
Satellite Controller
(provided)
(provided)
DVD/VCR DVD
AUDIO OUT L-1
IN/OUT
Y
P
LEFT B
RIGHT P R
COMPONENT
VIDEO OUT
DIGITAL
AUDIO OUT
PCM/ L-2 IN/DECODER
STREAM
SAT CONTROL
COAXIAL OPTICAL
DVD
SAT CONTROL L-2 IN/DECODER
SAT
1 2 3
4 5 6
7 8 9
0
8
DISPLAY
The following procedure is required if you receive satellite channels
through a satellite receiver. Approximately 20 seconds before the
S V timer programming (
HOW IEW
programming (
and automatically switches the satellite receiver's channels using a
provided Satellite Controller.
Installing Satellite Controller
1
Place a Satellite Controller so that the path between its
transmitter and the satellite receiver's remote sensor is
unobstructed.
2
Fix securely using the adhesive strip attached on the back of the
Satellite Controller.
3
Be sure to connect the unit's L-2 IN/DECODER connector to the
satellite receiver's 21-pin SCART connector.
NOTE:
When connecting your satellite receiver, refer to its instruction manual.
4
Connect the Satellite Controller to the SAT CONTROL
connector on the rear panel.
Setting Satellite Receiver's Brand And Channel
After installation, set the satellite receiver's brand and channel
correctly; otherwise, the Satellite Controller cannot work correctly.
● Turn on the unit.
● Turn on the TV and select the AV mode.
● Slide the TV/CABLE/SAT/DVD switch to DVD.
1
Turn on the satellite receiver's power.
2
Press SET UP to access the Main Menu screen.
3
Press w e to select "INITIAL SET UP", then press ENTER.
4
Press w e to select "SAT/
GUIDE PR", then press ENTER.
5
Press rt to select "SAT
BRAND", then press ENTER.
6
Press rt to select the brand
code from the list on page 22,
then press ENTER.
● If the brand code you entered is
invalid, the code field will be reset.
IN
Enter the correct brand code again.
● If the unit is in playback or recording mode, you cannot set the brand
OUT
ANTENNA
code.
7
Press the appropriate number
keys to enter one of the channel
positions on the satellite receiver,
then press ENTER twice. The unit
enters the Test mode.
● You can select the channel
position between 1 to 999.
INITIAL SETTINGS
pg. 43) or Manual Timer
pg. 44) starts, the unit sets its input mode to "L-2"
21
EN