Note For Printed Wiring Boards And Schematic Diagrams - Sony MHC-GPX5 Servise Manual

THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
For Printed Wiring Boards.
Note:
• X : Parts extracted from the component side.
• Y : Parts extracted from the conductor side.
• : Internal component.
f
• : Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side: Parts on the pattern face side seen
(Conductor Side) from the pattern face are indicated.
Parts face side: Parts on the parts face side seen from
(Component Side) the parts face are indicated.
Caution:
Pattern face side: Parts on the pattern face side seen
(SIDE B) from the pattern face are indicated.
Parts face side: Parts on the parts face side seen from
(SIDE A) the parts face are indicated.
• Abbreviation
E4 : African model
E2 : 120V AC area in E model
E51 : Chilean and Peruvian models
MX : Mexican model
BR : Modelo Brasil
HCD-GPX5G/GPX7G/GPX8G
For Schematic Diagrams.
Note:
• All capacitors are in μF unless otherwise noted. (p: pF) 50
WV or less are not indicated except for electrolytics and
tantalums.
• All resistors are in Ω and 1/4 W or less unless otherwise
specifi ed.
• : Internal component.
f
• 2 : Nonfl ammable resistor.
• 5 : Fusible resistor.
• C : Panel designation.
Note: The components identifi ed by mark 0 or dotted
line with mark 0 are critical for safety.
Replace only with part number specifi ed.
• A : B+ Line.
• B : B– Line.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
no mark : TUNER (FM)
* : Impossible to measure
• Voltages are taken with VOM (Input impedance 10 M).
Voltage variations may be noted due to normal production
tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal production
tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F : AUDIO
f : TUNER (FM/AM)
: MIC
N
J : CD PLAY
E : USB
• Abbreviation
E4 : African model
E2 : 120V AC area in E model
E51 : Chilean and Peruvian models
MX : Mexican model
BR : Modelo Brasil
• Localização das Placas
4CH DAMP board
REGULATOR, SWITCHING board
SWITCH board
MOTOR (LD) board
DISPLAY board
VOLUME board
USB board
27 27
HCD-GPX5G/GPX7G/GPX8G
DMB22 board
MIC board (for GPX7G/GPX8G)
TUNER1AM3R board
MAIN board
SENSOR board
MOTOR (TB) board
DRIVER board