Oil Level Sensor; Indicator Switch Inspection - Honda NU50 Shop Manual

~HONDA
~NUSO.NUSOM
ELECTRICAL EQUIPMENT
INSPECTION
OIL LEVEL SENSOR
BLACK
/
-,r~
GREEN
GREEN/RED
BLACK
/
.-
OIL LEVEL
SENSER
Resistance
J
5 - lSn
Tet'm~=
l
Green/Red 1+) - Black (-J
Green (-I
Disconnect the coupler and remove the sensor.
lower the float fully all the way.
Measure the resislances between the terminals as
shown.
FLOAT
OIL LEVEL INDICATOR
INDICATDR SWITCH INSPECTION
Connect the coupler and turn the ignition switch
ON.
With the float fully raised, measure the resistance
between the terminals.
Green/Red 1+) to Black I-I
I
340n approx.
Operate the turn signals to see that the battery circuit
is nO/mal, then perform the following inspectIon.
RaIse and lower the float to make sure that the oil
leve! indicator lamp blinks.
Should the lamp fail to go on and go out as the float
IS
moved up and down, check lor loose connections
and repeat the above procedure.
( ~i~:HG~OE~0~F~F=4.5t
LOmm
GO N
Dale of Issue: Noy., 1981
(} HONDA MOTOR CO., L TO.
151 13-17