Network Setup - Samsung HT-J7750W User Manual

Network Setup

When you connect this product to a network, you
can use network based applications and functions
such as Smart Hub and BD-LIVE, and upgrade the
product's software through the network connection.
For more information about accessing and using
Internet services, see the Network Services chapter
of this manual on pages 43~50. Instructions for
configuring the network connection start below.
Configuring Your Network Connection
If you didn't configure your network connection during
the initial settings procedure or you need to reset the
network connection, follow the directions below.
Before you begin, contact your Internet Service
Provider to find out if your IP address is static or
dynamic. If it is dynamic, and you have a wired
or wireless network, we recommend using the
Automatic configuration procedures described below.
If you are connecting to a wired network, connect the
product to your router using a LAN cable before you
start the configuration procedure.
To begin configuring your network connection, follow
these steps:
1. In the Home screen, select Settings, and then
press the OK button.
2. Select Network, and then press the
3. Select Network Settings, and then press the
OK button.
4. Go to the instructions for Wired networks
starting or the instructions for Wireless networks
starting on the next page.
Wired Network
K
Wired – Automatic
After following Steps 1 to 3 above:
1. In the Network Settings screen, change
Network type to Wired. Then, select Connect
and press the OK button. The product detects
the wired connection, verifies the network
connection, and then connects to the network.
2. When it is done, highlight OK, and then press
OK button.
K
Wired - Manual
If you have a static IP address or the automatic
procedure does not work, you'll need to set the
Network Settings values manually.
After following Steps 1 to 3 above:
1. In the Network Settings screen, change
Network type to Wired. Then, select Connect
and press the
The product searches for a network, and then
displays the connection failed message.
✎
If it is possible to connect the home cinema to
your network wirelessly, select Change Network
at this point, change the Network type to
Wireless, and then go to the instructions for
wireless networks on the next page.
Network Settings
Wired network connection failed.
Unable to connect to the network. Try the following: check if your IP address is set
correctly in IP Settings. Contact your Internet service provider for more information.
Change Network
OK button.
Use the :; buttons to select IP Settings,
2.
and then press the
screen appears.
3. Select the IP setting field, and then set it to
Enter manually.
4. Select a parameter to enter (IP Address, for
example), and then press OK. Use the 78
buttons on the remote control to enter the
numbers for the parameter. Or use the Num
keypad to enter a parameter number. Press and
hold the 123 button until the Num pad appears
on the screen. When the Num pad appears,
select a number using the 78:; button and
then press the
on the remote control to move from entry field to
entry field within a parameter. When done with
one parameter, press the
Press the 7 or 8 button to move to another
5.
parameter, and then enter the numbers for that
parameter following the instructions in Step 4.
23
- English
OK button.
MAC Address XX:XX:XX:XX:XX:XX
IP Address
Subnet Mask
Gateway
DNS Server
IP Settings Retry
OK button. The IP Settings
button. Use the :; buttons
OK
OK button.
0. 0. 0. 0
0. 0. 0. 0
0. 0. 0. 0
0. 0. 0. 0
Close